download Care must be taken when installing this accessory to ensure damage does
not occur to the vehicle. The installation of this accessory should
follow approved guidelines to ensure a quality installation. These
guidelines can be found in the “Accessory Installation Practices”
document. This document covers such items as:- — Vehicle Protection (use
of covers and blankets, cleaning chemicals, etc.). — Safety (eye
protection, rechecking torque procedure, etc.). — Vehicle
Disassembly/Reassembly (panel removal, part storage, etc.). — Electrical
Component Disassembly/Reassembly (battery disconnection, connector
removal, etc.). Please see your Toyota dealer for a copy of this
document. 1. Remove Running Board from Packaging. (a) Remove running
board assembly from package and place on a clean protected surface. The
boards are sided (Fig. 1-1) (b) Verify kit contents and inspect the
running board for damage. 2. Running Board Preparation for Installation
(LH/RH Side). (a) Verify hardware bag content by referring to the cover
page of this instruction sheet. (b) Loosen the 1/4 – 20 flange nuts at
each of the three (3) bracket locations on each running board. (Fig.
2-1) (c) With a small slotted screwdriver, remove the plastic plugs
covering M8 weld nuts in body of vehicle at 6 points/side.
Comments for "2005 - 2010 Toyota Tacoma Running Board Repair"
Post a Comment