1. Remove the load space trim panel. For additional information, refer
toSection 501-05. 2. Remove the spare tire. 3. Remove the LH rear
bumper cover to rear quarter panel nuts. 4. Remove the RH rear bumper
cover panel nuts. 5. Remove the rear bumper cover nuts. 6. Raise and
support the vehicle. For additional information, refer to Section
100-02. 7. Remove the four splash shield screws, two pin-type
retainers and position the LH and RH splash shields aside to access the
rear bumper cover attachment bolts.
8. Remove the two rear bumper cover to rear quarter panel nuts. 9.
Remove the pin-type retainers. 10. Disconnect the drain tube. 11.
Remove the rear bumper cover screws. 12. NOTE: The rear side marker
light connector is between the cover and the body and must be
disconnected when removing the bumper cover. Remove the rear bumper
cover. 13. To install, reverse the removal procedure.
2003 Ford Taurus/ Sable Rear Bumper Cover Removal and Installation Direct Download speed 7287 Kb/s
Comments for "2003 Ford Taurus / Sable Rear Bumper Cover Removal and Installation"
Post a Comment