1. Disconnect the battery ground cable. Wait one minute. WARNING: WAIT
AT LEAST ONE MINUTE AFTER DISCONNECTING THE BATTERY CABLES BEFORE
REMOVING THE FLOOR CONSOLE. FAILURE TO FOLLOW THIS INSTRUCTION MAY
INCREASE THE POSSIBILITY OF ACCIDENTALLY DEPLOYING THE AIR BAG(S) AND
MAY CAUSE PERSONAL INJURY. 2. Remove the rear floor console screws.
Move seat fully forward. NOTE: Contour shown, SVT similar. 3. Fully
apply the parking brake. 2. Remove the rear floor console screws.
NOTE: Contour shown, SVT similar. 3. Fully apply the parking brake. 5.
Detach the shift bezel from the selector housing. 1 Remove three bolts.
2 Detach shift bezel from the console. 6. Raise and remove the rear
floor console. NOTE: The rear floor console must be raised to disengage
the front retaining clips. 7. Remove the four front floor console
retaining screws. 8. Detach the front floor console. 1 Set the
gearshift lever into position 1. 2 Partially remove the front floor
console. 9. Disconnect the cigar lighter electrical connections and
remove the front center console. INSTALLATION 1. To install, reverse
the removal procedure.
Comments for "2000 Ford Contour Floor Console With Automatic Transaxle Removal"
Post a Comment