Removal and Installation NOTE: If an A/C condenser core leak is
suspected, the A/C condenser core must be leak tested before it is
removed from the vehicle. For additional information, refer to Section
412-00. NOTE: Installation of a new suction accumulator is not required
when repairing the air conditioning system, except when there is
physical evidence of system contamination from a failed A/C compressor
or damage to the suction accumulator.
1. Recover the refrigerant. For additional information, refer to
Section 412-00. 2. Remove the battery. For additional information,
refer to Section 414-01. 3. Remove the pin-type retainers and the
radiator upper sight shield. 4. Disconnect the condenser fittings. •
Discard the O-ring seals. 5. NOTE: LH radiator bracket shown, RH
similar. Remove the bolts and remove the radiator brackets. 6. NOTE:
RH condenser bracket nut shown, LH similar. Remove the condenser
bracket nuts. 7. Tilt the radiator back and remove the A/C condenser
core. 8. To install, reverse the removal procedure. • Install new
O-ring seals lubricated in clean PAG oil. • Lubricate the refrigerant
system with the correct amount of clean PAG oil. For additional
information, refer to Section 412-00. 9. Evacuate, leak test and
charge the refrigerant system. For additional information, refer to
Section 412-00.
Comments for "2004 Ford Crown Victoria How to Remove and Install Condenser Core"
Post a Comment