Removal and Installation 1. Disconnect the battery ground cable. For
additional information, refer to Section 414-01. 2. Remove the
accelerator cable snow shield. 3. Detach the spark plug wire retainer.
4. Detach the wiring harness from the intake manifold support. 5.
NOTE: The upper intake manifold is removed for clarity. Release the
fuel charging wiring harness from the valve cover studs. Position the
wiring harness away from the camshaft position sensor. 6. Remove the
camshaft position (CMP) sensor. 1 Disconnect the electrical connector.
2 Remove the screws and the CMP. 7. NOTE: Make sure that the fuel
charging wiring harness is fully secured to the valve cover studs. To
install, reverse the removal procedure.
2003 Ford Taurus/ Sable, Camshaft Position (CMP) Sensor 3.0L (2V) Removal And Installation
Direct
Comments for "2003 Ford Taurus/ Sable, Camshaft Position (CMP) Sensor 3.0L (2V) Removal And Installation"
Post a Comment